• English

    What is an SMA connector assembly
     Nov 17, 2021|View:347

    What is an SMA connector assembly? Because this connector is relatively small in our life and has a special name, few people know and understand it. Let's learn about it today.

    Before we know, let's look at the RF connector convention

    SMA connector assembly is required on several circuit boards that require some 50 ohm impedance to connect to external antennas (Bluetooth, cellular, GPS, XBee and Nordic). However, some boards use SMA connector assemblys of different gender and polarity. Therefore, we need to match different antennas according to the gender or polarity of RF connectors.

    There are 4 different types of SMA connector assemblys with gender combination, in which gender refers to the center pin and polarity refers to the rotation characteristics.

    What is an SMA connector assembly

    SMA connector assembly

    The initial SMA design required two compatible connectors:

    The above two connectors are designed to be used together, but there is a problem with this configuration, and the FCC is moving towards part 15 compliance. This means that all SMA RF connectors are changing gender (center pin). For those of us who need to pair the antenna with RF equipment, this is really annoying. The FCC's gender change is to prevent home users from damaging RF devices when screwing the antenna (think of home WiFi). If all antennas are buses, the central connector cannot be damaged.

    However, there is a polarity, all antennas, cables or anything are connected to a potential fixed object, using external nut or internal thread design and all fixed equipment. This is applicable to all products. Therefore, all our antennas are SMA male or RP-SMA female. All of our plates were SMA female or RP-SMA male.

    RP-SMA connector

    The only change in compliance with part 15 is the change of the center pin, which forms a "new" standard;. Reverse polarization SMA (RP-SMA). RP (reverse polarity) is named after its "thread gender" and has an opposite gender needle.

    If the circuit board does not have a u.fl connector connected to the external antenna, the RF board and antenna will use a combination of old (SMA) and new (RP-SMA):

    Cellular and GPS (900 / 1700 / 1800MHz and 1.57542ghz, respectively) usually use the old standard. The antenna adopts SMA male type and the module adopts SMA female type.

    Any 2.4GHz (Bluetooth, ZigBee, WiFi and Nordic) communication usually uses the new standard. RP-SMA female is used on the antenna and RP-SMA female is used on the module.

    In fact, we ignore gender issues most of the time. If you have an RP-SMA board or module, you need to match the corresponding SMA and RP-SMA antenna. Just make sure to match the antenna frequency with the circuit board.

    SMA antenna connector is also a kind of connector, but its special male and female interface makes us think it is very special. In fact, our parents should have seen this connector. In the 1980s and 1990s, the cable TV we watched at home was this interface. Of course, now our private family TV has long been replaced by wireless digital technology.